ACCESSORIES

Typical steel fittingsfor fibre optic cables

Material: galvanized steel

SHACKLE

GN-16 T | 0,550 kg | 12.500 daN

EYE CHAIN LINK

ESP-16 | 0,600 kg | 12.500 daN

TWISTER CHAIN LINK

ESR-16/A | 0,500 kg | 12.500 daN

TWISTER CHAIN LINK

ESR-16 | 0,475 kg | 12.500 daN

SHACKLE

GN-16 T | 0,550 kg | 12.500 daN

EYE CHAIN LINK

ESP-16 | 0,600 kg | 12.500 daN

TWISTER CHAIN LINK

ESR-16/A | 0,500 kg | 12.500 daN

TWISTER CHAIN LINK

ESR-16 | 0,475 kg | 12.500 daN

SAG ADJUSTER LINK

NT-1 | 3,400 kg | 13.500 daN

EXTENSION LINK

TA-1/L | 5,5 kg/m | 12.500 daN

Material: Galvanized nodular graphite cast iron

THIMBLE

G-16 | 0,800 kg | 12.500 daN

C-BLOCK

N SCF-16 | 12,500 kg | 10.000 daN

Tap off connectors for fibre optic earthwires

Material: aluminium alloy (body), steel hot dip galvanized (bolts and nuts)

If you want to know all the technical specifications, download the PDF document.

Earthing connectors for fibre optic earthwires

Material: aluminium alloy (body), steel hot dip galvanized (bolts and nuts)

If you want to know all the technical specifications, download the PDF document.

Armour grip suspension clamps for fibre optic earthwires OPGW

Materials: aluminium alloy (body and armour rods), stainless steel (hinge and cotter pin), steel hot dip galvanized (bolts and nuts), neoprene (insert)

If you want to know all the technical specifications, download the PDF document.

Dead end clamp with breakaway screws for fribre optic earthwires OPGW

Material: aluminium alloy (body, cover and breakaway screws); stainless steel (ground connector screw), hot dip galvanized steel (through bolt)

This type of dead end clamp has been designed for installing on these cases where, either by design specifications either by other causes, is not possible the installation of helical fittings. The installation is very simple and the breakaway screws make no necessary the use of torque wrenches.

Please, consult the Technical Department of SAPREM for type selection

Helical dead-ends for fibre optic earthwires OPGW

Material: aluminium clad steel

If you want to know all the technical specifications, download the PDF document.

Retenciones helicoidales preformadas para cables de fibra óptica autosoportados Helical dead-ends for ADSS fibre optic cables

Material: aluminium clad steel (dead end) and aluminium alloy (protection splice)

If you want to know all the technical specifications, download the PDF document.

Fittings for ADSS fibre optic cables in short spans

Depending on the parameters of the line and cable, the Technical Department of SAPREM will study very best solution

Downlead clampsfor fibre optic cables

Material: forged steel, hot dip galvanized or aluminium alloy (body); aluminium alloy (clamp); stainless steel and galvanized steel (bolts and nuts)

If you want to know all the technical specifications, download the PDF document.

Descargar (PDF, 1.12MB)